[Fixed] 0.10.0 Cannot convert using imported presets
Posted: Sat Feb 07, 2015 4:57 pm
I'm trying to convert a batch of videos. Since I have two computers, I want to split the job between the two. One is running Windows 8, the other one is OSX 10.10. I created and tested a few profiles on the Windows machine and queued some files. It worked well. I then exported those profiles, and imported them into my Mac. This is where the problem begins.
If I just select the files, set all the parameters manually, it goes well. But, if I choose any of the profiles imported from the Windows version of Handbrake (same version, 0.10.0), I can't proceed any further. After clicking on the profiles, I cannot queue or even start any conversion, even when I change any of the settings (like, the CRF, bitrate, etc.). When I try to add a batch of files to the queue by clicking on "File" > "Add All Titles to Queue", the confirmation dialog shows up, but clicking any of the buttons (continue or cancel) didn't give me anything (i.e. the dialog won't even close when I click on cancel).
The application itself does not crash, it's just all of the controls no longer work after choosing any of imported profiles.
If I just select the files, set all the parameters manually, it goes well. But, if I choose any of the profiles imported from the Windows version of Handbrake (same version, 0.10.0), I can't proceed any further. After clicking on the profiles, I cannot queue or even start any conversion, even when I change any of the settings (like, the CRF, bitrate, etc.). When I try to add a batch of files to the queue by clicking on "File" > "Add All Titles to Queue", the confirmation dialog shows up, but clicking any of the buttons (continue or cancel) didn't give me anything (i.e. the dialog won't even close when I click on cancel).
The application itself does not crash, it's just all of the controls no longer work after choosing any of imported profiles.